13
Installing the Weights
Rear Cutting Unit with Groomer
Only, with Rear Grass Basket
Parts needed for this procedure:
Carriage bolt (5/16 x 2-1/4 inches), Part No.
1
3230-7—sold separately
Carriage bolt (5/16 x 3-1/4 inches), Part No.
1
3230-13—sold separately
Carriage bolt (5/16 x 4-1/2 inches), Part No.
1
3230-30—sold separately
2
Spacer
1
Flange nut (5/16 inch)
Locknut (5/16 inch), Part No. 3296-47—sold
2
separately
2
Weight
6
Small weight (Part No. 132-0734-03—sold separately)
Procedure
For a rear cutting unit with the groomer kit and the
rear grass basket installed (no rear roller brush kit),
refer to
Figure
25.
Also install the weights on the front cutting units.
Note:
For front cutting units with the groomer kit and
the front grass baskets installed (no rear roller brush
kit), refer to
Figure
23.
Note:
The center cutting unit does not work with both
the rear roller brush kit and the rear grass basket kit.
Rear cutting unit with groomer and rear grass basket
1. Bolt (5/16 x 4-1/2 inches),
sold separately
2. Bolt (5/16 x 2-1/4 inches),
sold separately
3. Bolt (5/16 x 3-1/4 inches),
sold separately
4. Spacer (2), sold separately 8. Small weight (4), sold
14
Finishing Installing the
Universal Groomer Drive
Kit
No Parts Required
Procedure
1.
Set the desired height of groom for each
cutting unit; refer to
Height-of-Groom (HOG) Settings (page 17)
Adjusting the Groomer Height (page
2.
Install the cutting units; refer to the Operator's
Manual for your machine.
15
Figure 25
installed
5. Weight (2), supplied with
the kit
6. Locknut (5/16 inch), sold
separately
7. Flange nut (5/16 inch),
sold separately
separately
Height-of-Cut (HOC) and
17).
g192301
and