Advanced Settings; Programming The Remote For Tv Operation (Input Sync: Sony Tv Only) - Sony RHT-G800 Operating Instructions Manual

Advanced Settings

Programming the remote
for TV operation (Input
SYNC: Sony TV only)
If you connect a Sony TV, follow the steps below
to program the remote. The TV input will be
selected automatically (Input SYNC).
Note
• Do not use the HDMI control function while the Input
SYNC function is active.
For details, see the HDMI CONRTOL Guide of the
stand.
TV
(orange)
Input
buttons
(TV, DVD/
BD, SAT,
AUDIO)
1
Press TV (orange) while holding down
the input button (TV, DVD/BD, SAT,
AUDIO) for the component you want to
operate.
For example, if you are going to operate a
DVD player, press DVD/BD.
The input button you pressed flashes.
2
Check the table below for the remote
button number corresponding to the TV
input jack you have connected to, and
press the number.
The input button (TV, DVD/BD, SAT,
AUDIO) lights up when you press the
number button.
TV input jack*
VIDEO 1
VIDEO 2
VIDEO 3
VIDEO 4
VIDEO 5
VIDEO 6
VIDEO 7
VIDEO 8
COMPONENT 1
COMPONENT 2
COMPONENT 3
COMPONENT 4
HDMI 1
Number
HDMI 2
buttons
HDMI 3
HDMI 4
ENTER
HDMI 5
TV program**
None
* TV input jack name may differ depending on
your TV model.
** This setting switches from the current input to
TV program.
Tip
• Press 20 if you do not want to send signals to the
TV.
3
Press ENTER.
The setting is completed after the input
button you pressed in step 1 flashes twice.
4
Repeat steps 1 to 3 to program the
remote.
Notes
• An error has occurred when the input button you
pressed in step 1 flashes five times. Perform this
process from step 1 again.
Remote Button
(codes)
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
20
continued
25
GB