Sony VPL-CX75 Operating Instructions Manual page 11

Network Channel: when [Ad-hoc (Peer-
to-peer)] is selected in [Network Mode],
you can select from 1 to 11.
When [Wireless Access Point] is
selected in [Network Mode], [Auto] is
selected automatically.
Notes
• If the USB wireless LAN module is
connected to the computer, remove it before
setting.
• You may not be able to use some channel
according to the country.
Data Encryption (WEP): select the data
encryption system.
You can select from among [Off], [64
(40) bit ASCII], [128 (104) bit ASCII],
[64 (40) bit HEX], [128 (104) bit HEX].
When [Off] is selected, [Key] becomes
invalid.
Key: when [Data Encryption (WEP)] is
used, enter the key.
Enter the same key as that of the
computer or access point.
The number of the characters/figures is
due to the setting of the [Data
Encryption (WEP)].
• 64 (40) bit ASCII: five characters/numbers/
symbols
• 128 (104) bit ASCII: 13 characters/numbers/
symbols
• 64 (40) bit HEX: ten numbers from 0 to 9/
characters from a to f
• 128 (104) bit HEX: 26 numbers from 0 to 9/
characters from a to f
Note
When [64 (40) bit ASCII] or [128 (104) bit
ASCII] is selected, the capital and small letters
are discriminated.
IP Address Setting: select [Auto
(DHCP)] or [Manual].
When the [Manual] is selected, set [IP
Address], [Subnet Mask] and [Default
Gateway].
Note
A DHCP server is needed to make DHCP
valid.
IP Address: select the IP address setting
from among 0 to 255.
Subnet Mask: select the subnet mask
setting from among 0 to 255.
Default Gateway: select the default
gateway setting from among 0 to 255.
MAC Address: the MAC address of the
attached wireless LAN card is displayed.
You can set the projector by using the
browser. See "Projector setting" on page
18 ("Setting/Operating via Web").
To save the setting
Select the [Ok] button and press the ENTER
key. The settings are saved and the home
display appears.
To clear the setting menu without
saving the setting
Select the [Cancel] button and press the
ENTER key.
Wireless Connection
11