Maintenance; General Practices - Toro Groundsmaster 3320 Installation Instructions Manual

Maintenance

Adjusting the Rear Cover Latch
1. Adjust the latch assembly (Fig. 22) up or down if the
cover does not seal properly or if the cover does not
latch when operating.
1
Figure 22
1. Latch assembly
Caution
Never work on hopper unless it is in the
lowered position.

General Practices

1. Keep the unit clean, checking that engine is free of dirt
and chaff. Make sure all fasteners are tight. Check the
deflectors, baffles and shields for wear and replace as
needed.
2. Clean grass clippings from the hopper, chute, blower
and cutting unit after each use. Wash the underside of
the cutting unit daily with a hose. An excessive buildup
of clippings will impair the collection system
performance.
3. Refer to Cutting Unit and Traction Unit Operator's
Manuals for service requirements of each.
Lubrication
After every 25 hours of operation, grease the cylinder and
all pivot points with No. 2 multi–purpose lithium base
grease. There are (8) grease fittings at various pivot points
and (1) fitting on each end of cylinder (Fig. 23).
Figure 23
14