Emergency Cd-Rom Tray Release - Fujitsu 565Tx User Manual

S e c t i o n F i v e
ful boot sequence you should turn off the power
with the Power Switch and contact your
support representative.
*Real time clock error – Real-time clock fails
BIOS test. May require board repair. Contact
your support representative.
*Shadow RAM Failed at offset:nnnn – Shadow
RAM failed at offset nnnn of the 64k block at
which the error was detected. You are risking
data corruption if you continue. Contact your
support representative.
nnnn Shadow RAM Passed – Where nnnn
is the amount of shadow RAM in kilobytes
successfully tested.
*System battery is dead – Replace and run
SETUP – The BIOS CMOS RAM memory hold
up battery is dead. This is part of your BIOS
and is a board mounted battery which requires
a support representative to change. You can
continue operating but you will have to use Setup
Utility default values or reconfigure your Setup
Utility every time you turn off your notebook.
This battery has an expected life of 2 to 3 years.
24
System BIOS shadowed – System BIOS copied
to shadow RAM.
*System CMOS checksum bad – run SETUP –
BIOS CMOS RAM has been corrupted or
modified incorrectly, perhaps by an application
program that changes data stored in BIOS
memory. Run Setup and reconfigure the system.
*System RAM Failed at offset:nnnn – System
RAM failed at offset nnnn of in the 64k block at
which the error was detected. This means that
there is a fault in your built-in memory. If you
continue to operate you risk corrupting your data.
Contact your support representative for repairs.
nnnn System RAM Passed – Where nnnn is
the amount of system RAM in kilobytes
successfully tested.
*System timer error – The timer test failed. The
main clock that operates the computer is faulty.
Requires repair of system board. Contact your
support representative for repairs.
UMB upper limit segment address: nnnn
Displays the address of the upper limit of
Upper Memory Blocks,indicating released
segments of the BIOS memory which may
be reclaimed by a virtual memory manager.
Video BIOS shadowed – Video BIOS success-
fully copied to shadow RAM
.

EMERGENCY CD-ROM TRAY RELEASE

If for some reason the eject button fails, you
can open the CD-ROM tray with a paper clip
or similar tool inserted into the eject hole in the
far right side of the front of the tray. Straighten
one side of a paper clip and push it gently into
the hole. The tray will p op out a short distance.
(Figure 5-1.)
Figure 5-1 Emergency CD-ROM Tray Release