SWITCHING POWER ON/OFF
Turn the Power switch/ Volume control clockwise to switch the transceiver ON.
Turn the Power switch/ Volume control counterclockwise fully to switch the
transceiver OFF.
Transceiver Password
If your transceiver is password protected, the LED will light blue when you turn the
transceiver ON. Enter the password (up to 4 digits) using the following procedure.
1 Set the Selector to position "1".
2 Press the Side 1 or Side 2 key to enter the first digit.
•
The Side 1 key increases the digit value and the Side 2 key decreases it.
The transceiver announces the digit number as it changes.
3 Repeat step 2 for Selector positions 2 ~ 4.
•
If there are less than 4 password digits, repeat for only the number of digits
the password contains.
4 Press the PTT switch to confirm the password.
•
When the correct password is entered, the Blue LED turns off.
ADJUSTING THE VOLUME
Rotate the Power switch/ Volume control to adjust the volume. Clockwise
increases the volume and counterclockwise decreases it.
SELECTING A ZONE AND CHANNEL
1 Select the desired zone using the key programmed as [Zone Up] or [Zone
Down].
•
Each zone contains a group of channels.
2 Select the desired channel using the Selector (default).
•
Each channel is programmed with settings for transmitting and receiving.
TRANSMITTING
1 Select the desired zone and channel.
2 Press the key programmed as [Monitor] or [Squelch Off] to check whether or
not the channel is free.
•
If the channel is busy, wait until it becomes free.
3 Press the PTT switch and speak into the microphone. Release the PTT switch
to receive.
BASIC OPERATION
12