Advertisement
Testing
Adjusting
Display
Brightness and
Contrast
4
2. Activate the touchpad by pressing 8 + CODE + 0 + 2 . All connected alphanumeric touch-
pads show a flashing * and all connected fixed display touchpads show PRESS STATUS.
3. Enter program mode by pressing 8 + installer/dealer CODE + 0 + 0 and program the
panel using the panel Installation Instructions.
4. When programming is completed, exit programming mode and disconnect the programming
touchpad.
To connect a programming touchpad to a Concord panel with software versions 1.0–1.6:
1. Disconnect AC and backup battery power.
2. Connect the cable plug onto the panel Programming Touchpad Header pins (Figure 6).
3. Reconnect the AC and backup battery power. The touchpad briefly displays ***********,
SCANNING BUS DEVICES, then shows a time and date display.
Note
If the touchpad does not respond as described in step 3, there may be a bus conflict. To correct this,
change the touchpad unit number as described in the section "Changing the Touchpad Unit Number."
Removing the programming touchpad from Concord panels with software versions 1.0–1.6:
To prevent a trouble condition, you must delete the programming touchpad unit number from
Concord panel memory before disconnecting it.
1. After programming is completed, return to the ACCESSORY MODULES menu, then press ƒ .
The display should read BUS DEVICES.
2. Press and hold the D and 6 buttons together for at least 2 seconds. The display shows DA n,
where n is the touchpad unit number (0 - 3 for Concord Express, 000 - 015 for all others).
3. Press ‚ and wait for the display to show the BUS DEVICES menu.
4. Press ƒ . The display shows the lowest unit number and its device name.
5. Press the A, B, or menu scroll buttons until the display shows the programming touchpad
unit number.
6. Press D to delete the device and its unit number from panel memory.
7. Exit program mode and disconnect the programming cable from the panel header.
Note
Contact the central monitoring station before activating alarms, to avoid dispatching local police and fire
departments.
Test the touchpad by arming/disarming the system, activating the touchpad panics, bypassing
sensors, and by turning chime and lights on/off to verify correct operation. Refer to the panel
User's Manual for complete system operating instructions.
The touchpad display can be adjusted for easier viewing to help compensate for lighting condi-
tions in the touchpad location.
The brightness adjustment lightens or darkens the background. The contrast adjustment lightens
or darkens the text.
To adjust display brightness:
1. Enter user programming mode by pressing 9 + user, partition, or system master CODE .
The display shows SYSTEM MENU, then TIME AND DATE
(Concord panels with software versions 1.0–1.6 display USER CODES.)
2. Press the A, B, or menu scroll buttons until the display shows OPTIONS, then press ƒ . The
display shows DOWNLOADING ON/OFF (current setting).
3. Press the A, B, or menu scroll buttons until the display shows TOUCHPAD BRIGHTNESS 2
(default setting).
4. Enter a setting from 0 (darkest background) to 3 (brightest background), then press ƒ . The
display flashes the entered selection, then stops after pressing ƒ and displays the new setting
and brightness level.
5. Exit user programming mode.
To adjust display contrast:
Enter configuration mode by pressing the D and 6 buttons together for at least two seconds.
1.
The display shows DA n.
ATP2100 & ATP2600 Touchpads Installation Instructions
Advertisement
