Table of Contents
Advertisement
4. Insert the paper stack as far as it will go into the fax unit, with the
PAPER SENSOR
• Make sure that the leading edge of the paper is inserted all the way
into the MP tray so that it is below the paper-feed roller. The paper
sensor for the MP tray is located to the left of the paper feed roller,
when viewed from the front of the fax unit. Please note the following
points when loading small-size paper in the MP tray. (If the paper is
not loaded correctly, the paper will not be detected by the fax and a
message will appear asking you to load paper in the MP tray.)
• Make sure that the paper stack is not higher than the load-limit marks
(
2-46
Setting Up
print side facing up and the top of the paper going into the fax
unit first. Then adjust the paper guides to the size of the paper.
) on the paper guides.
PAPER-FEED
ROLLER
LOAD-LIMIT
MARK
Chapter 2
Advertisement
Table of Contents
