Table of Contents
Advertisement
3.1 Add Encoding Device
In the main menu interface, click ― Add, Edit or Delete Device‖ to go to the following interface as shown below.
Then click ― Add‖ to add devices. You can add multiply devices in this interface, such as face detection IPC, face recognition
IPC/NVR/box, face recognition terminal, perimeter alert IPC, ANPR camera, etc.
3.1.1 Quickly Add
Click [Refresh] to quickly search devices in the same local network as shown below. Check the device and allocate the transfer server,
storage server, area for it. After that, click [OK].
Click ― Default password‖ to set the default username and password of the devices from different manufacturers, such as Hikvision, Dahua,
PMS, etc. The default username of the standard device is ― admin and the default password of the standard device is ― 123456‖.
Note: * The default media transfer server and storage server can be selected when adding devices. Users can also create new media
transfer server and storage server in advance (see Add Media Transfer Server and Add Storage Server).
* Area must be set up before adding devices. Click [Add Area] to create an area (See Area Setting).
3.1.2 Manually Add
①
Enter IP address/IP range/domain name, username and password and choose protocol type.
②
Click [Test] to test whether the device is connected successfully or not.
③
Select transfer server, storage server and area and then click [OK].
Devices can be added in batch by adding IP range.
If ― URL‖ is selected, you shall add the device via RTSP protocol. Enter the URL, username and password of the device and then click
3
Device Management
6
MVMS Management Server User Manual
Advertisement
Table of Contents
