Mechanical systems
MOBILETT Plus only
Adjustment and replacement of the turn plate
DANGER
Equipment required: 2 pieces of wood (50 x 70 x 500 mm)
•
The turn plate mechanism must be removed for adjustment or replacement.
•
Ensure compliance with the safety information in the section:
"Safety information and protective measures".
Fig. 13
MOBILETT Plus only
•
Remove the supporting wheels.
•
Jack up and block the unit securely 5 cm above the floor. This must be done properly so
that the unit does not tip over.
•
Disconnect all cables, ground connection and K68, according to (Fig. 13).
Siemens-Elema AB
Solna, Sweden
Never work with the system open if the capacitor is charging or
has just been charged.
The capacitor bank may still be charged even if the system is
switched OFF and the mains cable is disconnected.
Life-threatening electric shock hazard exists.
See Chap.:
"Protective measures when working on the capacitor bank".
Shaft
SPR8-215.898.02
Rev. 01
Locking
ring
K68
Page 11 of 28
01.02
SPS-UD
10 - 11
10
Locking ring
MOBILETT Plus/ Plus E