Pre-Maintenance Procedures; Preparing The Machine For Maintenance; Lifting The Machine - Toro Workman GTX EFI Operator's Manual

Pre-Maintenance
Procedures
Preparing the Machine for
Maintenance
1. Park the machine on a level surface.
2. Shift the transmission to the N
3. Engage the parking brake.
4. Shut off the engine and remove the key.
5. Empty and raise the cargo bed.

Lifting the Machine

DANGER
The machine may be unstable when using
a jack. The machine could slip off the jack,
injuring anyone beneath it.
• Do not start the machine while the machine
is on a jack.
• Always remove the key from the key switch
before getting off the machine.
• Block the tires when the machine is
supported by lifting equipment.
• Use jack stands to support the machine
once you have lifted it.
Important:
Whenever you run the machine for
routine maintenance and/or diagnostics, ensure
that the rear wheels of the machine are 25 mm (1
inch) off the ground, with the rear axle supported
on jack stands.
•
The lifting point at the front of the machine is
located at the front of the frame, behind the towing
tongue (Figure 23).
position.
EUTRAL
•
30
Figure 23
1. Front lifting point
The lifting point at the rear of the machine is
located under the axle tubes
Figure 24
1. Rear lifting points
g034043
(Figure 24).
g034044