Using The Z Stand - Toro Z Master Professional 6000 Series Operator's Manual

Figure 41
1. Full-width ramp in stowed
position
2. Side view of full-width
ramp in loading position
3. Not greater than
15 degrees
g027996
4. Ramp is at least 4 times
as long as the height of
the trailer or truck bed to
the ground
5. H=height of the trailer or
truck bed to the ground
6. Trailer

Using the Z Stand

The Z Stand raises the front end of the machine to
allow you to clean the mower and remove the blades.
WARNING
The machine could fall onto someone and
cause serious injury or death.
• Use extreme caution when operating the
machine on the Z Stand.
• Use the Z Stand only for cleaning the
mower and removing the blades.
• Do not keep the machine on the Z Stand
for extended periods of time.
• Always shut off the engine, set the
parking brake, and remove the key before
performing any maintenance to the mower.
Driving up onto the Z Stand
Important:
Use the Z Stand on a level surface.
1. Raise the mower deck to the transport position.
2. Remove the bracket pin
1. Z Stand
2. Bracket pin
3. Bracket
3. Raise the latch.
34
TM
(Figure 42).
Figure 42
4. Bottom of slot
5. Latch
g010172