Programme Packages; Disinfection Prog. Code; Auto Load Control; Automatic Dispensing - Miele PWM 508 Mop Star 80 Operating And Installation Instructions

Supervisor level

Programme packages

The selection of programmes can be
expanded by activating single pro-
grammes from the programme pack-
ages.
The programmes selected from the pro-
gramme packages are displayed under
Further programmes .
- Standard
- Pre-treat mops
- Pre-treat cloths
- Ready to use
- Workwear
- Standard programmes
After selecting the programme pack-
ages, the individual programmes from
the list are activated (activated pro-
grammes are marked with a frame). The
selection must then be confirmed.

Disinfection prog. code

A code has to be entered to cancel a
disinfection programme. The code can
be modified.
The code is: 0 0 0
Tip: Make a note of your new code if
you ever change it.
80

Auto load control

This washing machine comes with
automatic load control. In some pro-
grammes, the water levels and the
programme cycle times are adapted to
the load. If the auto load control is de-
activated, the machine will always
carry out the programme sequence
based on a full load.
Factory default: On

Automatic dispensing

Automatic dispensing via an external
dispensing system can be activated
Factory default: Off

Peak load signal

The peak-load negotiation function
enables the washing machine to be
connected to an energy management
system. When a signal is registered,
the washing machine's heater is
switched off for a short period. The
washing machine may only be oper-
ated with a peak-load system if this
system is connected to the washing
machine via the Miele XCI box.
- No function (factory default)
- Peak load with 230 V
- Peak load with 0 V