Toro Workman GTX Operator's Manual page 5

injury or death. Drive carefully. To prevent tipping
or loss of control, take the following precautions:
– Use extreme caution, reduce speed, and
maintain a safe distance around sand traps,
ditches, creeks, ramps, any unfamiliar areas,
or other hazards.
– Watch for holes or other hidden hazards.
– Use caution when operating the machine
on a slope. Normally, travel straight up and
down slopes. Reduce speed when making
sharp turns or when turning on hillsides. Avoid
turning on hillsides whenever possible.
– Use extra caution when operating the machine
on wet surfaces, at higher speeds, or with a full
load. Stopping time increases with a full load.
– Avoid sudden stops and starts.
– Do not attempt sharp turns or abrupt
maneuvers or other unsafe driving actions that
may cause a loss of control of the machine.
– When dumping, do not let anyone stand behind
machine and do not dump the load on anyone's
feet.
– Keep all bystanders away. Before backing
up, look to the rear and ensure that no one is
behind the machine. Back up slowly.
– Watch out for traffic when near or crossing
roads. Always yield the right of way to
pedestrians and other machines. Always
signal your turns or stop early enough so other
persons know what you plan to do. Obey all
traffic rules and regulations.
– Never operate the machine in or near an area
where there is dust or fumes in the air which
are explosive. The electrical and exhaust
systems of the machine can produce sparks
capable of igniting explosive materials.
– Always watch out for and avoid low overhangs
such as tree limbs, door jambs, over head
walkways, etc. Make sure there is enough
room over head to easily clear the machine
and your head.
– If you are ever unsure about the safe operation
of the machine, stop your work and ask your
supervisor.
•
Before getting off the seat, do the following:
– Stop the movement of the machine.
– Lower the bed.
– Engage the parking brake.
– Remove the key.
•
If the machine ever vibrates abnormally, stop the
machine immediately, and wait for all motion to
stop and inspect for damage. Repair all damage
before resuming operation.
•
Lightning can cause severe injury or death. If
lightning is seen or thunder is heard in the area, do
not operate the machine; seek shelter.
5