Table of Contents
Advertisement
Installation & Setup Guide
22. Release Playback
• Pressing the [REL-PB] button will release the Cue List on the selected playback master. The cue pointer will
remain at the current cue position, therefore pressing [GO] will put you back into the same state you were in before
you hit [REL-PB].
• Press [SHIFT] [REL-PB] to release all Cue Lists.
• Press and hold [REL-PB] and a [SELECT] button to release that Cue List and not change your currently viewed
Cue List.
23. Select
• Press a [SELECT] button to determine which Cue List cues will be written to by default when you record cues.
The 'selected' Cue List will have an amber LED flashing. Other playbacks that have Cue Lists assigned to them
will have solid amber LEDs.
• Pressing this button is the same as using the mouse to highlight a Cue List in the Cue List directory.
• To quickly record cues to a Cue List (even if it is not the currently selected Cue List) press [SHIFT] [RECORD]
then [SELECT]. The new cue will be appended to the end of the Cue List and the current Cue List selection will
not change.
24. Shift
• Use with [REL-PB] to release all Cue Lists.
• Use with [STEP FORWARD/BACKWARD] buttons to go to the top or bottom of a Cue List.
• Use with [ARROW KEYS] to select a range of cells with the blue box.
• Use with [GO] to assert the appropriate Cue List.
• Use with [BACK] to run the previous cue in cue time.
• Use with [UP] or [DOWN] to adjust the selected channel's level by one percent.
• Use with Split Crossfaders or Single Crossfaders (A/B C/D fader setup under [S3] Hardware Setup) to manually
move backwards through a Cue List.
• When the command line is empty, holding down [SHIFT] and rolling the level wheel will scroll the channel grid.
• Use with [MOVE] to open the Move dialogue box.
• Use with [COPY] to open the Copy dialogue box.
• Use with [RECORD] to open the Record dialogue box.
• Use with [UNDO] or [REL] to restore previously released channels. If all three stages of release were used, this
will return them in three stages, in order.
• Use with [REL-PB] to release all Cue Lists.
• Use with [STEP FORWARD/BACKWARD] buttons to go to the top or bottom of a Cue List.
• Use with [ARROW KEYS] to select a range of cells with the blue box.
• Use with [GO] to assert the appropriate Cue List.
• Use with [BACK] to run the previous cue in cue time.
• Use with [UP] or [DOWN] to adjust the selected channel's level by one percent.
• When the command line is empty, holding down [SHIFT] and rolling the level wheel will scroll the channel grid.
2 8
Controls
Palette II Lighting Control Console
Advertisement
Table of Contents
