Option port board
For a list of available option port boards, see
An option port board can be installed near the back of the system board that provides an additional connector
on the rear I/O panel.
NOTE:
The image in this section shows an HDMI port expansion board.
To remove the option port board:
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the air duct
4.
Remove the two Phillips screws (1) that secure the board to the system board.
5.
Lift to disengage the board from the system board connector, and then remove the board from the
computer (2).
To install the option port board, reverse the removal procedures.
Boards, cards, and ports on page
(Preparation for disassembly on page
(Access panel on page
(Air duct on page
47).
21).
9.
20).
Option port board
57