Removing And Installing An M.2 Ssd Storage Card - HP EliteDesk 800 G3 SFF Maintenance And Service Manual

7. Connect the power cable (1) and data cable (2) to the rear of the hard drive.
NOTE:
dark blue SATA connector on the system board labeled SATA0. If it is a secondary hard drive, connect the
other end of the data cable to one of the light blue SATA connectors on the system board.
8. Rotate the drive cage back down to its normal position.
IMPORTANT:
9. Reassemble the computer.

Removing and installing an M.2 SSD storage card

NOTE: The computer supports 2230 and 2280 M.2 SSD cards.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Rotate the hard drive cage to its upright position
44 Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
If the 2.5-inch hard drive is the primary drive, connect the other end of the data cable to the
Be careful not to pinch any cables or wires when rotating the drive cage down.
(Access panel on page
(Front bezel on page
(Preparation for disassembly on page
21).
21).
(Hard drive cage on page
20).
41).