Changing The Rhythm Volume; Adjusting The Tempo - Yamaha Electone STAGEA ELC-02 Owner's Manual

Changing the rhythm volume

There are two ways to set the rhythm volume: using the
VOLUME buttons on the panel and using the volume
slider in the display. The volume buttons let you make
coarse adjustments to the volume while the slider gives
you fine control.
Using VOLUME buttons on the panel
(coarse):
Press one of the VOLUME buttons of the rhythm on the
panel to set the desired level.
The buttons have five volume settings, from a minimum
of 0, or no sound, to a maximum of full volume.
Using VOLUME slider in the display
(fine):
Pressing the same rhythm button on the panel again (or
pressing the rhythm name of the selected rhythm in the
display) calls up the Rhythm Condition display.
To set the volume, touch the PERCUSSION VOLUME
slider in the display or use the Data Control dial. The
control range is from 0 (no sound) to 24 (full volume).
NOTE
Depending on the volume value (set by the slider), two adjacent
VOLUME lamps may be lit at the same time, indicating an
intermediate position.
Selecting Rhythms with the Rhythm Buttons

Adjusting the tempo

Use the TEMPO buttons (as shown below) to decrease or
increase the tempo.
TEMPO Indicator
Decreasing the tempo Increasing the tempo
TEMPO display shows the current tempo. Displayed
values are given in beats per minute.
The tempo range is 40 to 240 beats per minute.
When the rhythm begins playing, the TEMPO indicator
changes function to a BAR/BEAT indicator.
BAR/BEAT Indicator
Bar (measure) Beat
On the BAR/BEAT indicator, the number on the left
indicates the current bar or measure and the one on the
right indicates the number of the beat in each bar.
You can also see the Tempo and Bar/Beat indications in
the Voice Display. In the Voice Display, both Tempo and
Bar/Beat can be seen in one display.
Reference page
• Voice Display (page 17)
ELC-02/ELCU-M02 Owner's Manual
5
57