Toshiba E-STUDIO352 Printing Manual page 254

5 Printing from Windows
Stapling and Hole Punching
You can staple and punch the paper.
Stapling is not available if a finisher is not installed.
Hole Punching is not available if a hole punch unit is not installed.
Stapling the paper
1
Display the Finishing tab and check the "Staple" check box. Then
select how to staple.
Upper Left — Select this to staple the printed document in the upper left.
Upper Right — Select this to staple the printed document in the upper right.
Center Top — Select this to staple the printed document double along the top edge.
Middle Left — Select this to staple the printed document double along the left side.
Center Double — Select this to fold and staple the printed document double in the
center.
The selectable options vary depending on the paper size.
"Center Double" can be selected only when the Saddle Stitch Finisher is installed and
configured on the Configuration tab.
2
Set any other print options you require and click [OK].
3
Click [OK] or [Print] to send the print job.
The output is stapled for each copy.
Punching holes
1
Display the Finishing tab and check the "Hole Punch" check box.
Then select how to hole punching.
Center Top — Select this to create holes along the top edge.
Middle Left — Select this to create holes along the left side.
2
Set any other print options you require and click [OK].
3
Click [OK] or [Print] to send the print job.
The output is hole punched.
252 Printing with Extended Print Functionality