Kenwood TK-290 Service Manual page 13

TK-290
TP5
TP4
E
When enter the self programming mode, "FUNC" ap-
pears after "SEL" is displayed for half a second.
Selecting any of Channel setting, Group setting, Function
setting, or Clone master with the [Top 1] [Top 2] keys and
then pressing [PTT] sets the Setting mode for that time.
Key operations in Self programming mode are as follows.
[Selector switch] : Not used
[PTT] : Functions as a RUN or Execute key
[Top 1] : Use as a Down key
[Top 2] : Use as an Up key
[Side 1] : Use for select channel steps in Chan-
nel setting mode, or switching for
QT/DQT.
[Side 2] : Use as a cancel key
[Orange] : Add or delete frequencies in Channel
setting mode
[Toggle] : Flipping this to the right while in
Channel setting mode, shifts to MHz
steps.
Attach the lead wire with plug
or
[Side 1] + [Side 2] + Power on
12
REALIGNMENT
X57-5390-10
Component side
Fig. 6
"SEL"
[PTT]
"CHAN"
[Top 1]
[Top 2]
[PTT]
"GROUP"
[Top 1]
[Top 2]
[PTT]
"FUNC"
[Top 1]
[Top 2]
[PTT]
"CLONE"
3-2. Channel Setting Mode
Set data for each channel while in this mode. After first
entering Self programming mode, select the "CHAN" dis-
play with [Top 1] [Top 2] and press [PTT] to set Channel Set-
ting mode. Once in Channel Setting mode, select the group
that needs setting with the [Top 1] [Top 2] keys and press
[PTT]. Next select the channel for setting with the [Top 1]
[Top 2] keys and press [PTT]. The setting items and setting
data will then appear so reset the data with the [Top 1]
[Top 2] keys and press [PTT]. When finished, the display
shifts to the next setting item. After finished setting all
items press [PTT] to return to Group selection. Changes in
the frequency CH steps and the QT/DQT steps can be made
in [Side 1].
No. Function name Display
Select 1.–1 during
Group/Channel group selection
1–1. during
channel selection
1 RX frequency R150.0125
2 RX signalling RX 023N
3 TX frequency T150.0125
4 TX signalling TX 250.3
5 Option signalling 2ToneA
6 DEL/ADD D/A ADD
7 Wide/Narrow WIDE
8 PTT ID ID OFF
9 TX power POW HI
10 Busy channel lockout BCL OFF
11 Beat shift SFT OFF
• Channel step display
Remarks
1–160~160–1
Receive frequency
Receive QT/DQT
(Dot on right edge is
lit up during 1 step
changes)
Transmit frequency
Transmit QT/DQT
(Dot on right edge is
lit up during 1 step
changes)
OFF, DTMF, 2ToneA,
2ToneB, 2ToneC
Delete, Add
Wide. Narrow
OFF, ON
High, Low
OFF, ON
OFF, ON
5kHz step
6.25kHz step
7.5kHz step
2.5kHz step
1.25kHz step