Bosch AMAX 2100 Installation Manual page 147

AMAX panel
Restore:
4
Supervise:
1.
2.
P
–
Condition:
No communication with DX3010 if DX3010 is available.
Restore:
4
Supervise:
1.
2.
P
–
Condition:
No communication with DX2010 if DX2010 is available.
Restore:
4
Supervise:
1.
2.
P
–
Module DX4010 Missing
Condition:
No communication with DX4010 if printer is available.
Restore:
4
Supervise:
1.
2.
P
Printer Missing
Condition:
Bosch Sicherheitssysteme GmbH
Restore the communication with DX4020 / ITS - DX4020G to a normal condition and reset
the fault. For more information, refer to DX4020-G, page 22.
Report the DX4020 / ITS - DX4020G fault to configured destination on address 124 when
the fault is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 8 for a detailed description).
When the fault is reset, send the restored report to the configured destinations.
The FAULT indicator is turned off, when there is no other system fault.
Output Expansion Module 1-2 Failure
Restore the communication with DX3010 to a normal condition and reset the fault. For
more information, refer to DX3010, page 18.
Report the DX3010 fault to configured destination on address 140 when the fault is
detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 8 for a detailed description).
When the fault is reset, send the restored report to the configured destinations.
The FAULT indicator is turned off, when there is no other system fault.
Input Expansion Module 1-6 Failure
Restore the communication with DX2010 to a normal condition and reset the fault. For
more information, refer to DX2010, page 16.
Report the DX2010 fault to configured destination on address 140 when the fault is
detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 8 for a detailed description).
When the fault is reset, send the restored report to the configured destinations.
The FAULT indicator is turned off, when there is no other system fault.
Printer Failure
Restore the communication with DX4010 to a normal condition and reset the fault.
Report the DX4010 missing fault to configured destination when the fault is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 8 for a detailed description).
When the fault is reset, send the restored report to the configured destinations.
The FAULT indicator is turned off, when there is no other system fault.
Installation Manual
Troubleshooting | en 147
2015.05 | 06 | F.01U.309.277