Table of Contents
Advertisement
5
Mounting
5.1
Microcontroller
1.
The microcontrollers(s) can be mounted horizontal or with the connectors oriented to
the bottom. The controller cannot be mounted with the connectors facing upwards.
2.
The mounting surface must be flat and all four bracket holes used.
3.
Sufficient space must be allowed for the mating and un-mating of the connectors.
4.
If the controller is mounted in the cab, valve extension cables are required to be routed
into the valve enclosure.
5.
If the controller is mounted in the valve enclosure, the main harness leads will
terminate directly to the valve solenoid.
6.
The mount hole spacing is 188mm (7.4") by 59mm (2.32").
7.
See the "Installation Notes" for additional recommendations (page 15).
Bosch Rexroth Canada ı May 2019 ı Revision 5.0
7/20
Hide quick links:
Advertisement
Table of Contents
