Table of Contents
Advertisement
AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
Figure 6-39 Fitting the metal shell onto the twisted-pair cable
Step 4 Fit the metal shell onto the twisted-pair cable until the shield layer is covered completely.
Along the edge of the metal shell, cut off the aluminum foil shield layer and ensure that there
is no surplus copper wire. The exposed twisted-pair cable is about 20 mm (0.79 in.) long, as
shown in
Figure 6-40 Removing the shield layer of a twisted-pair cable (unit: mm (in.))
Step 5 Lead the four pairs of twisted-pair wires through the wire holder, as shown in
Figure
Figure 6-41 Leading wires through the wire holder
Issue 03 (2019-04-01)
Figure
6-40.
6-42. Ensure that the colored wires are in the correct location in the cable.
C
G
Copyright © Huawei Technologies Co., Ltd.
6 Appendix
Figure 6-41
and
73
Advertisement
Table of Contents
