Table of Contents
Advertisement
AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
Step 3 Check whether the contact strips are clean. If they are not clean and the dirt cannot be
removed, replace it with a new RJ45 connector.
Figure 6-82 Dirt on a contract strip
Step 4 Check whether the contact strips and the plastic separators are well aligned and intact. If a
separator is skewed and cannot be fixed, replace it with a new RJ45 connector.
shows an unqualified piece.
Figure 6-83 Skewed plastic separators
Step 5 Hold the connector with the side facing towards you, and check whether you can see the
cross-sections of the wires. Ensure that the ends of the wires are in good contact with the edge
of the RJ45, and that the contact strip blade extends beyond the ends of the wires and is
crimped with the wires. If not, replace the connector.
Figure 6-84 Wires not in good contact with the edge of the RJ45
Issue 03 (2019-04-01)
Copyright © Huawei Technologies Co., Ltd.
Figure 6-82
shows an unqualified piece.
Figure 6-84
shows an unqualified piece.
6 Appendix
Figure 6-83
94
Advertisement
Table of Contents
