HP ENVY x360 Convertible Maintenance And Service Manual page 50

3. Disconnect all external devices from the computer.
4. Remove the top cover (see
NOTE: When replacing the system board, be sure that the following components (as applicable) are
removed from the defective system board and installed on the replacement system board:
● WLAN module (see
● Solid-state drive (see
Memory modules (see
●
● Heat sink (see
Remove the system board:
1. Disconnect the following cables from the system board:
(1): Display cable
(2): Touch board cable
(3): USB/card reader board cable
(4): Battery cable
(5): Speaker cable
(6): Power connector cable
2. Remove the two Phillips PM2.5×4.0 screws that secure the system board to the computer (1).
3. Remove the two Phillips PM2.5×4.0 screws (2) that secure the fan to the computer.
40 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Top cover on page
WLAN module on page
Solid-state drive (M.2) on page
Memory module on page
Heat sink on page 44)
27).
34)
32)
42)