Epson ELP-3000 Easy Setup

Plug the LCD
connector on the
Y-cable into the
projector5 Computer
IN/OUT port.

Using The Projector

a. Turn on the projector and then turn on the
computer.
b. If you're using a PowerBook™, choose Mirroring in
the Display Control Panel. If you're using a PC
laptop, you may have to set the display to appear
on both the computer's screen and the projector.
c. Zoom in the image (make it smaller) by rotating
the zoom ring.
d. Adjust the focus by rotating the focus ring and
zoom out to correct image size.
e. If the image is too high or too low, press the
purple buttons and raise or lower the projector.
f. Turn the feet to further adjust the height.
EPSON is a registered trademark of Seiko Epson Corporation. Other product names used herein ore for identification purposes only and may be trademarks of their respective owners. EPSON disclaimers any and all rights In those marks.
Copyright 8 1996 by Epson America, Inc., Torrance, California, USA
ELP-3000/3300
2
Plug the VGA connector on the
Y-cable into the laptop's monitor port.
A
Attach the Macintosh VGA adapter to
the VGA connector on the Y-cable.
See your
Owner's Manual
projector from your computer or use external audio
or video sources, an external speaker, or a desktop
computer.
Warning: Never look into the lens when the lamp is on.
Never lift or ho/d the projector by its lens.
If you need help or EPSON Road Service, call
1-800-922-8911.
Tighten the screws for all connectors.
Connect an AC adapter to the laptop or
PowerBook and plug it into a wall outlet.
B
Connect the Macintosh VGA
adapter to the PowerBook's video-
out cable.
if you want to control the
EPSON

Easy Setup

C
Plug the video-out cable into
the video-out connector on the
back of the PowerBook.
Take Along Checklist
and lamp
®
10/96