Sharp SRS Mounting System Installation Manual page 28

6
INS TA LL AT IO N WO Rk
4. Remove the lower tile from the roof.
5. Place the roof tile slider on the lower tile and align with
the horizontal line marked above. Mark two holes for
roof tile stand off.
Roof tile slider
AE-110
S Tile Low Profile Tile
(holes in valley) (holes in center)
1
Drill guides.
Never use drill
guide holes
for tile roof
standoff screw
Middle row,
holes 2 & 4
6. Drill 2 holes using supplied drill bit (AE112). A high
speed drill (approximately 1000 rpm) is required for
this process. Exert a pressure of 40 to 50 lb. Make
certain to dip the tip of the drill in water after drilling
Hole guide line
Flat Tile
(holes in center)
Align the end with
the hole guide line
Front row,
holes 1 & 3
Top row,
holes 3 & 5
each hole. This will cool the drill bit. Clean any debris
and dust after drilling.
Cool the drill bit
after drilling one
or two holes.
This will prolong
the life of the
drill bit.
CAUTION
Drill holes on the ground for safety reason.
7. Locate the rafter and place the aluminum support plate
on the deck. Install two 80 mm screws (XA02) through
the plate, spaced ~ 5" apart, into the rafter. Install four
35 mm screws (XA27) through the plate and into the
deck. The screws should be spaced equally along the
upper and lower edges of the plate.
Support AL screw (XA-27) 5.5 x 35
(into decking)
Support AL screw (XA-27) 5.5 x 35
(into decking)
Standard slider
mounting screw
(XA-02) 5.5 x 80
(into rafters)
Standard slider
mounting screw
Aluminum support plate
(XA-02) 5.5 x 80
(into rafters) (AK-111)
Aluminum support plate
(AK-111)
Rafter chalk line
Rafter chalk line
Pitch approx. 5"
Pitch approx. 5"
 8
Press down with about
40 - 50 lb of force.
Gather the tile
dust with a
vacuum cleaner
or brush & pan
Align the end of the
Standard slider
aluminum support plate
mounting screw
against the upper tile.
(XA-02) 5.5 x 80
Align the end of the
Standard slider
aluminum support plate
mounting screw
against the upper tile.
(XA-02) 5.5 x 80
Support AL screw
(XA-27) 5.5 x 35
(into decking)
Support AL screw
(XA-27) 5.5 x 35
(into decking)
Aluminum support
plate (AK111)
Rafter chalk line
Aluminum support
plate (AK111)
Rafter chalk line