Philips AED Trainer 3 Instructions For Use Manual page 14

8
1. Remove the HeartStart Training Pads III from their storage bag, leaving
them on their liner.
2. Remove the interconnect cable from its storage bag. Connect the pads
cable to the interconnect cable.
3. Plug the interconnect cable's yellow connector into the pads connector
socket on the front of the AED Trainer 3. Be sure the connector clicks
into place.
4. Place the AED Trainer 3 with the pre-connected pads in the carry case.
The case is designed to store the AED Trainer 3 with the pads pre-
connected.
The HeartStart Training Pads III are designed for up to 100 uses. To help
ensure continued performance, avoid leaving the pads in heat or direct
sunlight. To replace the pads, disconnect the connector plug from the AED
Trainer 3 and repeat Steps 1 through 3, above.
LAERDAL LINK TECHNOLOGY TRAINING PADS
To connect the Laerdal LINK Technology Training Pads to the AED Trainer 3,
follow the steps below.
1. Remove the Laerdal LINK Technology Training Pads from their storage
bag, leaving them on their liner.