LG ABNW18GBHC0 Engineering Product Data Book page 13

Compact
6. External pressure setting for
How to Set E.S.P. on the remote controller?
This is the function that decides the strength of the wind for each wind level and because this function is to make the instal-
lation easier.
• If you set ESP incorrectly, the air conditioner may malfunction.
• This setting must be carried out by a certificated-technician.
FAN
SPEED
TEMP
• Precaution shall be taken not to alter the E.S.P value corresponded to each air flow section.
• E.S.P value can be varied according to the products.
• In the case of going to the next air flow rate stage by pressing the fan-speed button during the setup of the E.S.P value,
the E.S.P value of previous air flow rate will be maintained by remembering the E.S.P value prior to the shift.
Indoor unit
1
2
3
OPER
MODE
4
5
When pressing the button and
button simultaneously for more than 3
seconds, the system will be entered into
the installer setting mode.
- After entering into the installer setting
mode, select the E.S.P code value by
pressing the OPER button.
MODE
* E.S.P code value : 03
Select the desired air flow rate with
FAN
the button. Whenever pressing
SPEED
the button, [SLO→LO→MED→HI→
FAN
SPEED
POW] will be indicated.
Select the desired air flow rate value
with the temperature up(▲), down(▼)
button.
* E.S.P value range : 0~255
- E.S.P value will be indicated at the upper
right section of the display window.
When pressing the button, currently
established E.S.P value will be set up.
When pressing the button and
button simultaneously for more than 3
seconds after the setting has been
completed, the setting mode will be released.
- If there isn't any button input for more
than 25 seconds, the installer setting
mode will also be released.
Ceiling concealed duct - Middle static pressure
OPER
MODE
OPER
MODE
_ 7