Rail Wear Strips - Yamaha SRS10ML53 Owner's Manual

Spacer
Spindle Axle
Ski Damper
Nut
Washers
Cap Screw
5. Apply an all-temperature grease to
the non-threaded portion of the cap
screw; then slide the cap screw
through the ski accounting for the
rubber damper, inserts, and washers.

NOTE: Install the cap screw so
the slotted nut will be located to
the inside of the ski.
6. Apply Yamabond Red Threadlocker
to the threads of the cap screw; then
tighten the nut to 6.2 kg-m (45 ft-lb).
7. Place the cotter pin into the ski cap
screw and spread the pin.
8. Repeat procedure for the other ski.

Rail Wear Strips

Yamaha recommends that the wear strips
be checked weekly and replaced as nec-
essary. Measure the wear strips at 254
mm (10 in.) intervals. Wear strips must
be 10.7 mm (0.42 in.) thick or thicker.
43
Inserts
Cotter
Pin
0749-261
If wear strip measurements are less than
specified, replacement of both wear strips
is necessary to prevent premature track
clip wear and possible track damage.
Take the snowmobile to an authorized
Yamaha Snowmobile dealer for this ser-
vice. This service is at the discretion and
expense of the snowmobile owner.
Each time a new set of wear strips are
installed, they should be tempered. Tem-
per the wear strips by driving the snow-
mobile for approximately a mile on a
hard pack trail; then immediately drive
into deep snow and allow the wear strips
to cool. Repeat the procedure (warming
up the wear strips; then cooling them
down) two or three times.

wear rapidly if the snowmobile is
operated on terrain on which the
snow cover is minimal. Loose
snow is required to cool and lubri-
cate the wear strips and prevent
accelerated wear.

Wheel Kit are available to reduce
wear strip wear.

packed snow conditions, it is rec-
ommended that Ice Scratchers be
installed to reduce wear strip wear
and engine overheating.
Minimum Thickness
NOTE: The rail wear strips will
NOTE: Two Wheel Kit and Four
NOTE: If operating on ice or hard-
0745-807