Modem Daughterboard Installation - Acer ARMC User Manual

Before You Start,
Continued
Avoid Electro-Static Discharge (ESD), Continued
Perform all unpacking and installation procedures on a ground-connected anti-static mat.
Wear an anti-static wristband grounded at the same point as the anti-static mat. You can
also use a sheet of conductive aluminum foil grounded through a one megaohm resistor
instead of the anti-static mat. Similarly, a strip of conductive aluminum foil wrapped
around the wrist and grounded through a one megaohm resistor serves the same purpose
as a wristband.

Modem Daughterboard Installation

The ARMC modem daughterboard is an optional component. Use the following steps to
install the modem daughterboard onto the ARMC card.
Step Action
1 Unpack the modem daughterboard.
2 Locate JP4 on the ARMC card. It has a series of pinholes that allow you to insert the modem
daughterboard. Match the modem daughterboard and the pin holes so that the pins align properly. Insert
the modem daughterboard by sliding it straight down into the ARMC card. See the illustrations on the
following page.
Note:
If the ARMC card is already installed into a host system, power down the host system and
ARMC card first. Physically unplug all external and internal cables from the ARMC card.
Remove the ARMC card from the host system.
3 Plug in the ARMC card into the host system and attach internal cables
4 Connect external cables
Note: For the complete ARMC card installation procedures, see your
Card
User's Guide located on the
Note: Inspect the cardboard carton for obvious damage.
140 Acer Remote Management Card (ARMC) User's Guide
Acer Remote Management
ARMC CD
.
Cont'd