Table of Contents
Advertisement
12
Safety precautions
Always observe the following before you install or operate the Altos
S300. For language translations of these statements refer to
Appendix B.
1.
This device is intended for installation in a restricted access
location only.
2.
If any of the components are removed, the resulting hole must be
blocked, by installing a component blank or replacing the
component. Failure to do so can seriously restrict air flow and
cooling.
3.
This device should be connected to a power source which carries a
fuse or circuit breaker that is greater than the rating of the shelf,
but also complies with national wiring standards.
4.
Allow disk drives and power supplies to reach room ambient
temperature before powering on the shelf.
5.
It is recommended that, if interconnecting equipment resided
within more than one equipment rack cabinets, these equipment
racks should be at the same ground potential.
6.
Warning! A possible shock hazard may exist in the area of the fan
connection.
7.
Warning! Disconnect both power supply inlets before opening
this equipment for servicing.
8.
Warning! Disconnect both power cables before servicing this
equipment.
2 Installation precautions
Advertisement
Table of Contents
