Table of Contents
Advertisement
4-14
for three seconds.
Blade Life Reset - Reset the blade life to zero
Press Home to return to the main control menu.
Press PGUP to go back to the previous setup page.
Press NEXT to go to the next setup page.
For machines with optional blade deviation detector
installed, additional two command are provided:
Deviation - Set deviation tolerance value based on
the precision requirement of your material.
Deviation ON/Off - Turn on or turn off the
deviation detector if installed.
Page 3 – cutting program setup
In this page you can set your desired cutting length
and quantity and see the number of finished cuts
(Cut Finished).
A total of 100 cutting jobs can be set and
performed under the automatic mode.
In "start job" and the "end job" field, fill in the
number of the cutting job you wish to start and end
with. The machine will automatically perform
cutting jobs within this range.
In Length column, set each respective cutting
length in mm or inch.
In Quantity column, set each respective cutting
quantity.
Press cut reset button for 3 seconds to reset the
cutoff quantity.
If you start a new set of program without clearing
cutoff data from previous job, the first cut (trim cut) will
be skipped as the second program is deemed as the
succeeding part of the previous program.
Press Home to return to the main control menu.
Press PGUP to go back to the previous setup page.
Press NEXT to go to the next cutting program setup
page.
Press P01, P05, P10, P15 to quickly jump between
cutting programs (Step 00 ~ 99)
Advertisement
Table of Contents
