Table of Contents
Advertisement
No
Item
7
8
9
10
11
4-10
Function
Material retract 2mm
ON/OFF
Single/Bundle cutting
mode
Coolant ON/OFF
Slow material feeding
mode
Trim cut ON/OFF
Description
individual cut is finished. Switching to manual mode at any
time other than cutting, the machine will proceed with the
next cut until it is finished.
When this function is turned on, the machine will retract the
material for 2mm after completing each cut before the blade
rises from its lowest position.
A solid yellow icon indicates the Material retract 2mm mode
has been turned on.
This button is used to switch between single or bundle
cutting mode.
Switch to single cutting model (
work piece.
Switch to bundle cutting mode (
work pieces.
When under bundle cutting mode, the feeding vise
must be touching the front limit switch for the blade to be
able to start.
Press this button to turn on the coolant pump.
A solid yellow faucet icon indicates the coolant pump has
been turned on.
Press again to turn off the coolant pump.
Used only when under Manual mode.
When the slow material feeding mode is turned on, the
material feeding speed will dramatically reduce to help you
position the work piece precisely.
This selection button works with the AUTO mode.
When under AUTO mode and before proceeding with your
automatic cutting jobs, select +0 if you wish the first cut to
be "trim cut" i.e. trimming the edge of your material without
the cut being counted into the "finished cuts."
In the other hand, select +1 if you do not need to trim cut
the material. The first cut will then be counted as the first cut
of your programmed jobs.
After the first cut begins, you may still change your
selection before the saw bow has descended to its lowest
point.
) to cut a single
) to cut a stack of
Advertisement
Table of Contents
