Kenwood DDX3028 Service Manual page 17

2-4. Protection when production mode is continued
If the production mode continues for 30 minutes, the unit
turns its power OFF, and power ON is disabled until reset.
3. Clearing the production mode
• Power OFF by the [POWER] key
• Power OFF by ACC OFF
• Power OFF by battery OFF
Clear the production mode by one of the 3 options above
and return to the normal mode.
SS mode
1. SS mode display (Layer 1)
Directly touch the item to select the operation
SYS V1000 TUN:Y
APP D2000 MON:Y
DATA V3000 TOU:Y
DISC V0065
Macrovision 0001
DivX 0001
BT V302
Span K
SYS-AREA : E DDX4
DISC-AREA : E reg : 2
S.No : 173X0021
INITIALIZE ALL
BACK
When not adjusted
TUN: N
MON: N
TOU: N
1-1. INITIALIZE ALL
Same as in service mode.
1-2. SERIAL WRITE & RGB TERMINAL CHK MODE
Mode for writing serial number.
In this mode, in order to also check electricity of all termi-
nals of RGB connector, video and audio selectors are fi xed
to RGB terminal.
q When this mode is selected, carry out the following pro-
cesses.
• Configure the NAVI communication terminal's serial
setting to the setting for serial writing.
• Set the video selector to RGB input.
• Set the audio selector to NAVI.
The display is switched to RGB and the image input from
the jig is displayed.
∗ The operator knows, by seeing the image switched, the
set is ready for serial writing.
TEST MODE
SERIAL WRITE & RGB TERMINAL CHK
MONITOR ADJUST MODE
BT MIC TEST
BT DONGLE CHECK
SMETER LEVEL CALIBRATION
TOUCH PANEL CALIBRATION
EXIT
DDX3028/3048/3058/318/4038/4038M
DDX4028BT/4038BT/4038BTM/4048BT/4058BT/418
BACK
w From hereafter, communication with the jig does not up-
date the display.
Display on the jig application indicates the status.
e When received from the jig "request for ending serial
writing mode", follow the process below.
• Set the NAVI communication terminal's serial setting
back to the normal operation setting.
• Set the video selector back to the original setting.
• Set the audio selector back to the original setting.
• Switch the display to the following GUI display.
Read the serial number written in and display in the fol-
lowing screen.
SERIAL WRITE & RGB TERMINAL CHK
COMPLETE
S.No : 173X0021
BACK
1-3. MONITOR ADJUST MODE
Mode for adjusting the image quality on the production line.
Utilize the PICTURE ADJUST UI and display the following.
Adjustment items are only 3 items, Drive R/G/B only, and
pressing the STORE button writes the adjustment value into
F. ROM.
EXIT
B– 064 B+
R– 064 R+
G– 064 G+
STORE
17