Removing The Packing Materials - HP StorageWorks 700ux Setup Manual

Optical jukebox
Table of Contents

Advertisement

Unpacking

Removing the packing materials

Remove the 700ux/1100ux jukebox packing materials (see
1. Cut the two plastic bands that secure the jukebox and packing materials to the
2. Open the box. Remove the accessory kit and set aside for later use.
3. Using at least two people, carefully lift the jukebox from the box, and set
4. Remove the two end caps from the jukebox.
5. Remove the antistatic bag from around the jukebox.
Note:
Pay special attention to areas behind any scuffs on the anti-static bag. If damage is
detected, contact your authorized service representative.
6. Store the packing materials for future shipment.
12
pallet.
WARNING:
The plastic bands are under tension and may snap away when
cut. Wear safety goggles when cutting the bands.
WARNING:
Do not move the jukebox without additional help or an
appropriately rated lift device. The jukebox weights approximately 30 kg
(66 lb).
aside.
Inspect the jukebox for any damage that may have occurred during shipment.
HP StorageWorks 700ux/1100ux Optical Jukebox Setup Guide
Figure 2
on page 13).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Storageworks 1100ux

Table of Contents