Basics; Making Calls - Sony ClearScan25 SPP-M100 Operating Instructions Manual

Basics

Making calls

TONE(*)
(HOLD)
Additional tasks
To
Put a call on hold
Switch to tone dialing
temporarily
Notes
• If you hear beeps during the conversation, move closer to the base unit;
otherwise, the call will be disconnected after 15 seconds. Note that, however,
you may not hear beeps if it's noisy on the handset.
• If you hear ringer tones during the conversation, another call is coming in on
the other line (see page 17).
Tip
You can also press (TALK) to make a call on line 1.
Line
lamps
Do this
Press (HOLD).
Press (LINE 1) or (LINE 2) (or (TALK) ) to
resume the conversation.
Press TONE (*) after you're connected.
The line will remain in tone dialing until
disconnected.
1
Pick up the handset from the
base unit.
2
Press (LINE 1) or (LINE 2) to
select the line, and wait until the
corresponding line lamp lights
up.
You then hear a dial tone. If you
hear beeps, move closer to the
base unit.
3
Dial the phone number.
4
When you're done talking, press
(TALK).
The line lamp goes off.
continued
EN
13
Basics