Cutting Unit Maintenance; Separating The Cutting Units From The Traction Unit - Toro Groundsmaster 3505-D Operator's Manual

Cutting Unit Maintenance

Separating the Cutting
Units from the Traction Unit
1. Perform the pre-maintenance procedure; refer
to Preparing the Machine for Maintenance (page
37).
2. Remove the hydraulic-motor-mounting screws
and disconnect and remove the hydraulic motor
from the cutting unit
Important:
Cover the top of the spindle to
prevent contamination.
Figure 67
1. Motor-mounting screws
(Figure 67).
3. Remove the lynch pin or retaining nut securing
the cutting unit carrier frame to the lift-arm-pivot
pin (Figure
1. Lynch pin
4. Roll the cutting unit away from the traction unit.
g031644
54
68).
Figure 68
2. Lift-arm-pivot pin
g031645