Related Manuals for Toro 30822
Summary of Contents for Toro 30822
- Page 1 Form No. 3326-156 27 Rotary Cutting Deck Groundsmaster 3500 Traction Unit Model No. 30822—210002001 and Up Operator’s Manual English (EN)
-
Page 2: Table Of Contents
..... Dealer or Toro Customer Service and have the model and serial numbers of your product ready. The model and serial Setup . -
Page 3: Safety
Safety Safety and Instruction Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. 98-7818 1. Warning—torque the blade bolt to 85–110 ft.-lb (115–149 N m). Read the operator’s manual for further instructions. -
Page 4: General Specifications
Note: Use this chart as a checklist to ensure that all parts have been received. Without these parts, total setup cannot be completed. Description Qty. Decal Apply to cutting deck for CE Parts Catalog Operator’s Manual Read before operating the machine. Registration Card Fill out and return to Toro. -
Page 5: Adjusting The Carrier Frame
Adjusting the Carrier Frame Adjusting the Height of Cut The front and rear cutting decks require different mounting Important This cutting deck often cuts approximately positions. 1/4 inch lower than a reel cutting unit with the same bench setting. It may be necessary to have these rotary cutting The front cutting deck has two mounting positions deck’s bench set 1/4 inch above that of reels cutting in the depending on what height-of-cut and degree of deck... -
Page 6: Adjusting The Roller Scraper
7. Install capscrew finger tight. 8. Repeat steps 4–7 for each side adjustment. 9. Tighten all three capscrews to 30 ft.-lb. (41 N m). Note: Adjustments of more than 1-1/2 inch may require temporary assembly to an intermediate height to prevent binding (e.g. -
Page 7: Maintenance
Check Condition of Deck After Operating Make sure cutting chambers are in good condition. To ensure optimum performance, clean underside of mower Straighten any bends in chamber components to assure housing. If residue is allowed to build up in mower correct blade tip/chamber clearance. -
Page 8: Separating The Cutting Decks From The Traction Unit
Separating the Cutting Decks Mounting the Cutting Decks to from the Traction Unit the Traction Unit 1. Position machine on level surface, lower cutting decks 1. Position machine on a level surface and shut engine off. to floor, shut engine off, and engage parking brake. 2. -
Page 9: Adjusting The Blade Plane
12 o’clock setting and within .03 in. of each other. is out of balance or if the blade is bent. Always use genuine Toro replacement blades to be sure of safety and optimum If any of these measurements are not within specification, performance. -
Page 10: Inspecting And Sharpening The Blade
If this time is greater than 7 seconds, the braking valve needs adjustment. Call your Toro Distributor for assistance in making this adjustment. Servicing the Rear Roller Disassembly Figure 13 1. - Page 11 3. Remove the lower screws securing each end of roller to roller mounts (Fig. 15). Figure 17 m–5417 1. Roller 4. Retaining ring Figure 15 2. Roller shaft 5. Oil seal 3. Ball bearing 1. Rear roller 3. Roller mount 2.
-
Page 12: Servicing The Front Roller
Servicing the Front Roller Cutting Deck Storage Disassembly If cutting deck is separated from traction unit for any length of time, install spindle plug (94-2703) in top of spindle to 1. Remove roller mounting bolt (Fig. 18). protect spindle from dust and water. 2.