Advertisement
Assembly
Read each step's instructions and study the drawing carefully to become
familiar with all the parts and procedures before beginning each step.
Step 1.
• Install the rear stabilizer (7) onto the main frame (1) with the four bolts
(65) and four at washers (84).
• Slide the handle bar assembly (6) onto the receiving tubes of the seat
carriage (4). Secure the handle bar assembly starting with the two
bolts (175) install from the inside hole of the receiving tube, and
assemble the two at washers (77) and two nuts (89). Secure the four
bolts (71) from the top side of the tubes and assemble the four at
washers (77) and four nuts (89).
• Attach the end of the gas shock to the seat back angle adjustment
bracket and secure with one bolt (118) and two at washers (115).
Attach the cover (24) located onto the bolt (175) with two nuts (91).
Tighten all hardware securely.
• Connect the left hand pulse wire (27) into the corresponding left socket
(42) located in the left plastic side case under the seat carriage, and
the right hand pulse wire (21) into the right socket (26).
Hardware for step 1
Part
Type
65
Hex head bolt
71
Hex head bolt
77
Flat washer
84
Flat washer
89
Nyloc nut
91
Nyloc nut
115
Flat washer
118
Hex head bolt
175
Hex head bolt
Description
Qty
3/8" × 2-1/4"
3/8" × 2"
Ø3/8"
Ø3/8"
3/8" × 7T
5/16" × 6T
Ø8.5
5/16" × 1-1/4"
3/8" × 2-3/4"
10
4
4
6
4
6
1
2
1
2
Advertisement
