Table of Contents
Advertisement
FLEXIDOME IP starlight 6000 VR
Notice!
Use only PoE approved devices.
Power-over-Ethernet can be connected at the same time as a 12 VDC power supply. If auxiliary
power (12 VDC) and PoE is applied simultaneously, the camera selects PoE and shuts off the
auxiliary input.
5.3.4
Auxiliary power
Connect a SELV-LPS or a SELV Class 2 power supply with a rated supply voltage of 12 VDC as
follows:
–
–
Caution!
Use only a +12 VDC power supply as an auxiliary power source.
!
The auxiliary power supply unit must be isolated from earth.
5.3.5
Alarm
Use the stranded and solid wires with maximum diameter AWG 22-28; only cut back 5 mm
(0.2 in) of insulation.
Alarm out:
Use the alarm output for switching external devices such as lamps or sirens.
The alarm output switching capability has max. voltage 30 VAC or +40 VDC; max. 0.5 A
continuous, 10 VA.
Alarm in:
Use the alarm input to connect external alarm devices such as door contacts or sensors:
–
–
Use a zero potential make-contact or switch as the actuator (with a bounce-free contact
system).
5.3.6
Audio
Connect audio devices to the audio input and audio output connectors.
The unit has full-duplex mono audio for two-way communication between a speaker or door
intercom system. The audio input signal is transmitted in sync. with the video signal.
Audio input:
Line input level (not suitable for direct microphone signal); impedance 18 kOhm typical;
1 Vrms maximum input voltage.
Audio output:
Line output level (not suitable for direct speaker connection); impedance 1.5 kOhm minimum;
0.85 Vrms maximum output voltage.
Use shielded audio connection cable with advised maximum cable lengths for audio line input
and output levels.
5.3.7
Video
Use the composite video connector (CVBS) on the camera to connect an analog monitor for
setting up the camera or as a permanent analog output for viewing or recording:
Bosch Security Systems B.V.
Cut back 7 mm (0.28 in) of insulation.
Connect the power wires (red+ , brown-) to the external power supply.
TTL logic, +5 V nominal, +40 VDC max, DC coupled with 50 kOhm pull-up to +3.3 V.
Configurable as active low or active high.
Installation manual
Installation | en
11
03.2019 | V2.0 | AM18-Q0711
Advertisement
Table of Contents
