Checking The Rear Wheel Toe-In; Cooling System Maintenance; Cooling System Safety; Checking The Cooling System - Toro 30605 Operator's Manual

Checking the Rear Wheel
Toe-In
Service Interval: Every 800 hours
1. Measure the center-to-center distance (at axle height) at
the front and rear of the steering tires.
Note: The front measurement must be 6 mm (1/4
inch) less than the rear measurement.
2. To adjust, loosen the clamps at both ends of the tie
rods.
3. Rotate the tie-rod end to move the front of the tire
inward or outward.
4. Tighten the tie-rod clamps when the adjustment is
correct.
Cooling System
Maintenance

Cooling System Safety

CAUTION
Discharge of hot, pressurized coolant or touching a
hot radiator and surrounding parts can cause severe
burns.
• Do not remove the radiator cap when the engine
is hot. Always allow the engine to cool at least 15
minutes or until the radiator cap is cool enough
to touch without burning your hand before
removing the radiator cap.
• Do not touch the radiator and surrounding parts
that are hot.
DANGER
Swallowing engine coolant can cause poisoning.
• Do not swallow engine coolant.
• Keep out of reach from children and pets.

Checking the Cooling System

Service Interval: Before each use or daily
Check the coolant level at the beginning of each day. The
capacity of the system is 8.5 L (9 US qt).
1. Carefully remove the radiator cap and expansion-tank
cap (Figure 65).
2. Check the coolant level in the radiator.
Note: The radiator should be filled to the top of the
filler neck and the expansion tank filled to the Full
mark.
1. Expansion tank
3. If the coolant is low, add a 50/50 mixture of water and
ethylene glycol anti-freeze.
48
Figure 65