Specifications; Attachments/Accessories; Before Operation; Before Operation Safety - Toro 30605 Operator's Manual

Specifications

Note: Specifications and design are subject to change
without notice.
Width of cut:
Overall
Front mower deck
Wing mower deck
Front and 1 wing mower deck
Overall width:
Mower decks down
Mower decks up (transports)
Overall length
Height
Height with ROPS
Ground clearance
Wheel tread (to center of tire)
Front
Rear
Wheel base
Net Weight

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
Operation

Before Operation

335 cm (132 inches)

Before Operation Safety

157 cm (62 inches)
General Safety
107 cm (42 inches)
246 cm (97 inches)
•
345 cm (136 inches)
183 cm (72 inches)
•
342 cm (135 inches)
140 cm (55 inches)
•
217 cm (85.3 inches)
17 cm (6-1/2 inches)
114 cm (45 inches)
119 cm (47 inches)
•
141 cm (55-1/2
inches)
1,856 kg (4,091 lbs)
•
•
19
Never allow children or untrained people to operate or
service the machine. Local regulations may restrict the
age of the operator. The owner is responsible for training
all operators and mechanics.
Become familiar with the safe operation of the equipment,
operator controls, and safety signs. Know how to stop
the machine and engine quickly.
Check that all safety devices are attached and
functioning properly. This includes, but is not limited to,
operator-presence controls; safety switches and shields;
the rollover protection system (ROPS); attachments; and
brakes. Do not operate the machine unless all safety
devices are in position and functioning as intended by
the manufacturer.
Always inspect the machine to ensure that the blades,
blade bolts, and cutting assembly are not worn or
damaged. Replace worn or damaged blades and bolts in
sets to preserve balance.
Inspect the area where you will use the machine and
remove all objects that the machine could potentially
throw.
Evaluate the terrain to determine the appropriate
equipment and any attachments or accessories required to
operate the machine properly and safely.