Samsung GALAXY S 5 SCL23 Basic Manual page 27

Table of Contents

Advertisement

<On the poolside>
•  Do not immerse the product in or splash it with pool water. Also, do 
not use the product underwater.
•  When the product gets pool water, which contains chlorine for 
disinfection, wash the product under the tap water*
temperature. Do not use brush etc. when washing it.
*1 A mild flow (6 liters per minute or less)
<In the kitchen>
You can use the product in the kitchen and other places where water 
is used.
•  Do not splash the product with or immerse it in soap water, 
detergent water, seasonings, juices, etc. other than tap water.
•  Do not immerse the product in or splash it with boiling water. The 
product is not resistant to high temperatures.
•  Do not place the product where it gets extremely hot or cold such 
as near a stove or in a refrigerator.
•  To watch TV (1Seg), place the product on the stable place.
■    Common precautions
microUSB connection terminal cover, back cover
Make sure that the microUSB connection terminal cover and back 
cover are firmly closed. Just a small particle (a hair, one grain of sand, 
etc.) between contact surfaces can cause water leak.
Do not open/close the microUSB connection terminal cover or attach/
remove back cover with gloved hands. Just a small particle (a hair, 
one grain of sand, etc.) between contact surfaces can cause water 
leak. Wipe off any minuscule droplets of water or dirt with a clean dry 
cloth before closing the covers.
If the microUSB connection terminal cover or the back cover is 
deteriorated or damaged, the waterproof/dustproof property becomes 
ineffective. In such case, contact an au shop near you.
If any liquid other than plain water gets on the product
If any liquid other than plain water (e.g. seawater, detergent, alcohol) 
gets on the product, immediately rinse it with plain water.
You can wash the product under a mild flow (6 liters per minute or 
less) of tap water at room temperature (5℃ to 35℃ ) at a distance of 
about 10 cm from the faucet or showerhead.
If the product gets dirty, wash it with your hands holding the back 
cover and the microUSB connection terminal cover so that they do 
not open. Do not use a brush or sponge.
After the product gets wet
After the product gets wet, drain water, and wipe the main unit and 
1
 at room 
the back cover with a clean dry cloth without removing the back cover. 
In cold climates, water on the main unit may turn to frost. Using the 
product with frost may cause a fault. Do not leave the product without 
wiping off the water. (No special measures against condensation have 
been implemented in this product.)
Rubber seals
The rubber seals on the inner edges of the microUSB connection 
terminal cover and the back cover are important to maintain 
waterproof/dustproof property. Do not damage or remove the rubber 
seals.
When closing the microUSB connection terminal cover and back 
cover, take care not to get the rubber seals caught. Forcibly closing 
the cover with the rubber seals caught may damage them resulting in 
loss of waterproof/dustproof. Just a small particle (a hair, one grain 
of sand, etc.) between contact surfaces can cause water leak. If any 
liquid other than plain water (e.g. alcohol) gets on the rubber seals, it 
may cause deterioration in durability.
Do not insert sharp objects into grooves around the microUSB 
connection terminal cover or the back cover. Doing so might damage 
or deform the product or damage the rubber seals, causing water leak.
It is recommended to replace the parts for maintaining waterproof/
dustproof property once every two years regardless of whether any 
abnormality is present. For information on part replacement, contact 
an au shop near you.
Charging
Never charge the battery if the main unit is wet.
The supplied and optional accessories are not waterproof/dustproof.
Waterproof property
Do not use the product in places where it may be sprayed with high-
pressure water (e.g. near a faucet or showerhead) or submerge it in 
water for extended periods of time, as the product is not designed to 
withstand high water pressure. Also, do not expose the product to a 
water flow stronger than the specified flow rate (i.e. 6 liters per minute 
25

Advertisement

Table of Contents
loading

Table of Contents