Related Manuals for Bosch Maxx WTL 6100
Summary of Contents for Bosch Maxx WTL 6100
- Page 1 Maxx WTL 6100 en Instruction Manual and Installation Instructions Internet: http://www. bosch-hausgeraete.de...
-
Page 2: Table Of Contents
Table of Contents Your new dryer ......Operating Notes on disposal ......Instructions Disposing of packaging . - Page 3 Cleaning and care ......Cleaning the dryer ..... . Frost protection / preparation for transport Cleaning the fluff filter .
-
Page 4: Your New Dryer
Your new dryer With the purchase of your new dryer, you have cho sen a modern, high quality domestic appliance. A distinctive feature of your dryer is its low energy con sumption. Every dryer which leaves our factory is carefully chek ked to ensure that it functions correctly and is in per fect condition. -
Page 5: Notes On Disposal
Notes on disposal Danger of suffocation Disposing of There is a danger of suffocation from the cardboard packaging box and plastic film. Do not allow children to play with the packaging. All the packaging materials are environmentally friendly and recyclable. Please dispose of the packaging in an environmentally responsible manner. -
Page 6: Safety Information
Safety information Using your dryer - Only for domestic use. correctly - Only for drying fabrics washed in water. - Do not leave children unsupervised near the dryer. Risk of explosion/fire Solvent danger. Do not use the dryer if: - the laundry has been treated with a solvent or has been colour treated (e.g. -
Page 7: Drying Your Laundry
Drying your laundry - Do not leave children unsupervised near the dryer. - Keep pets away from the dryer. - Remove all objects from pockets, especially ligh ters risk of explosion. End of programme - Switch off the dryer when the programme has en ded. -
Page 8: Notes On Environmental Protection/Economical Drying
Notes on environmental protection/economical drying Environmentally- - Spin the laundry thoroughly before drying. friendly and econo Spin the laundry thoroughly in the washing machi mical drying ne before drying. The higher the spin speed, the shorter the drying time and the lower the energy consumption. -
Page 9: Description Of The Dryer
Description of the dryer The dryer works on the principle of condensation. The Operation and condensation produced during the drying cycle is col special features lected in a container. The container should be emp tied after each drying cycle. Simple to use The water container does not have a lock on it. -
Page 10: Summary Of Instructions
Before drying Summary of 1. Open the door. instructions 2. Place the laundry in the drum. 3. Close the door. 4. Select a programme using the programme selec tor (see the table of programmes from page 16 onwards). 5. Press the Mu button. Inserting/removing laundryn0. -
Page 11: Appliance Design
Appliance design Water container Maintenance flap for condenser Door with filter Button for opening the unit maintenance flap... -
Page 12: Control Panel
Control panel Programme selector For switching the dryer on Indicator lamps Indicator lamps and off and selecting the programme. Can be turned (LEDs) for buttons which (LED) for emptying the in both directions. have been pressed. water container. Indicator lamps Start button for switching (LEDs) for the programme status. -
Page 13: Laundry Information
Laundry information Observe the following fabric symbols: Fabric symbols E = drying at normal temperature. D = drying at a lower temperature: Press the Jbutton too. F = do not tumble dry. Do not tumble dry the following fabrics: - Airtight fabrics (e.g. rubber coated fabrics). - Delicate materials (silk, curtains made from synthe tic material) they may crease. -
Page 14: Preparing To Use Your Dryer
Preparing to use your dryer Please read through this instruction manual carefully before using the dryer for the first time. 1. Open the door. 2. Place the laundry into the empty drum. i Ensure that the drum contains only laundry. 3. -
Page 15: Selecting A Programme
Selecting a programme Your dryer has various programmes and additional Selection functions for the best drying results. i Select the drying programme you require from the table of programmes (from page 16 onwards). Programme sequence During the Standard and Short programmes, the dryer uses an electronic sensor system which constantly monitors how wet the laundry is. -
Page 16: Standard Programmes
Standard programmes For cottons, coloured and linens. Standard programmes for Press the J button when drying heat sensitive fabrics. cottons and linens For laundry: Bed linen, table linen and towels which needs to be pressed Bed linen, table linen, towels, T shirts, which needs to be ironed polo shirts, work clothes up to 5 kg *... -
Page 17: Timed Programmes
Timed programmes for delicate fabrics made of acry Timed programmes lic or for subsequent drying or airing. Fabrics which have already been pre dried and are slightly damp, 30 min warm individual laundry items such as bath towels, bath robes, dishcloths and quilted fabrics made of acrylic. -
Page 18: End Of The Programme
End of the programme When the End" indicator lamp lights up:0. Anticrease function 1. Open the door. 2. Remove the laundry. The dryer is equipped with an automatic anti crease function (anti crease/End). It is effective if the laundry is not removed from the drum immediately. The drum rotates at specific time intervals for 1 hour. -
Page 19: Cleaning And Care
Cleaning and care Risk of explosion Cleaning the dryer There is a risk of explosion from the solvents. Never use solvents for cleaning. The dryer may be damaged if it is not cleaned properly. Do not spray the dryer with a water jet. Do not use scouring powder or general-purpose cleaners. -
Page 20: Cleaning The Fluff Filter
Bobbling (fluff) occurs as clothes etc. are used. These Cleaning the fluff bobbles come off during the drying cycle and collect filter in the fluff filter. The filter must be cleaned after each drying cycle. A clogged filter results in longer drying times and higher energy consumption. -
Page 21: Empty The Water Container
Do not drink this water. Empty the water Condensation accumulates during drying. This con container densation is collected in a container. The container should be emptied after each drying cycle.0. 1. Remove the container, holding it level. 2. Pour out the condensed water. 3. -
Page 22: Cleaning The Condenser Unit
The condenser unit should be cleaned three or four Cleaning the times a year, or more often if the dryer is used very condenser unit frequently. 1. Residual water may leak out so place an absor bent towel underneath the maintenance flap. 2. -
Page 23: What To Do If
What to do if ... Danger, electrical current. Repairs must only be carried out by the after sales service or an authorised expert. If you cannot rectify a fault yourself, or a repair is ne cessary: q Turn the programme selector to Off. q Remove the plug from the socket. - Page 24 What to do if ... Cause Solution One or more programme There has been a fault in the Clean the fluff filter and the status indicator lamps are programme sequence or operation. condenser unit (see pages 20 and flashing. 22). Check the installation conditions (see page 27).
-
Page 25: After Sales Service
After sales service Before calling the after sales service, check to see if you can rectify the fault yourself (see page 23 onwards). If you contact the after sales service, even within the warranty period, you will be liable for labour costs. Please inform the after sales service of the product number (E Nr.) and the production number (FD) of the appliance. -
Page 26: Technical Data
Technical data Size Measurement Height 86 cm (adjustable) Width 60 cm Depth 57 cm Weight approximately 45 kg Nominal capacity 5 kg Water container volume 3.2 l A.C. voltage, connected load, fuse See identification plate Consumption rates Spin speed in rpm Drying time Energy consumption (residual moisture) -
Page 27: Installation, Connection And Transportation
Installation, connection and transportation Risk of injury. Safety information The dryer is very heavy. Do not attempt to lift it on your own. Do not lift the dryer by any of the protruding parts (e.g. the door) they may break off. Risk of tripping. -
Page 28: Electrical Connection
Caution: Electrical The dryer must be connected correctly to an A.C. connection contactor socket. The mains voltage must comply with the voltage infor mation given on the identification plate (on the rear of the unit). The connected load and the necessary fusing are shown on the identification plate. -
Page 29: Accessories And Special Equipment
Accessories and special equipment Accessories can be fitted to modify the dryer for your needs. Please order accessories from a specialist supplier or from the after sales service. This kit is used to drain the condensed water using a Connecting kit for hose. -
Page 30: Washer Dryer Stack Connection Set
The dryer can be stacked on top of a Bosch washing Washer dryer stack machine of the same dimensions to save space. connection set Risk of injury. For reasons of safety, the appliances must be stacked Order no.: WTZ 1120 by an expert. -
Page 31: Reversing The Door Catch
The door catch can be reversed if necessary. Reversing the door The door is hinged on the right at the factory. catch You will need: - Torx screwdrivers, sizes T10 and T20. - Medium sized slotted screwdriver. These are available from specialist suppliers. Carefully tighten all screws by hand. - Page 32 Converting the dryer: 1. Remove both door fastening point covers: Lever them off carefully with a slotted screwdriver. 2. Undo both of the screws which are underneath and screw them in on the opposite side. 3. Replace both covers. 4. Undo the screw in the door lock cover. Remove the cover.
- Page 33 Converting and replacing the door. 1. Carefully lever off the locking catch cover. 2. Unscrew the locking catch. 3. Screw on the locking catch in the opposite posi tion. 4. Replace the locking catch cover. 5. Carefully lever off the hinge fastening point cover. 6.
- Page 34 7. Screw on the door hinges in the opposite position. 8. Replace both covers. 9. Place the hinge bracket on the front, holding the door firmly. 10.Screw the door first onto the top hinge, and then onto the bottom one. 11.Open and close the door carefully several times before using the dryer.
-
Page 35: Converting The Installed Load
The dryer has been designed for 10 or 16 amperes. Converting the If the dryer fuse (factory setting) does not correspond installed load to the socket fuse (household fuse), complete the fol lowing steps: 1. Connect the dryer to the mains electricity (see pa ge 28). - Page 36 Printed in Germany PW/ED 1 M 5550 006 277 1001 ROBERT BOSCH HAUSGERÄTE GMBH...