NEC Express5800/B120b User Manual page 63

Option Parameter
Set User Up to eight
Password alphanumerics
Password on
[Disabled]
boot
Enabled
Fixed disk boot [Normal]
sector
Write Protect
Power Switch [Disabled]
Inhibit Enabled
Security Chip Configuration Submenu
Option Parameter
TPM Support Disabled
[Enabled]
Current TPM –
State
Change TPM [No Change]
State
Enable & Activate
Deactivate & Disable
Clear
Description
Supervisor password controls
access to the setup utility.
When Enter is pressed, the user is
prompted for a password; press Esc
to abort. Once set, this can be
disabled by setting it to a null string,
or by clearing password jumper on
system board (refer to Configuring
Mother Board Jumpers in this
chapter).
Disables or enables password entry
on boot.
Will write protect the boot sector of
the hard drive to prevent viruses
from corrupting the drive under DOS
if set to write protect.
Enables or disables the POWER
switch mask feature. If "Enabled" is
selected, power-off with the POWER
switch becomes unavailable after
OS boot-up. (Forced shut down
feature is always acceptable to the
server. Forced shut down is a
feature to shut down by pressing the
POWER switch for at least four
seconds.)
Description
Disables or enables TPM feature.
Displays the current TPM state.
Changes TPM state.
(This option can be selected only
when the supervisor password is
set.)
Configuring Your Server 4-13
Your Setting
[ ]: Factory-set
Your Setting
[ ]: Factory-set