Using Wps Function Via Web-Based Interface; Using Wps Function Without Web-Based Interface - D-Link AC1200 User Manual

DIR-842V2 AC1200 Wi-Fi Gigabit Router
User Manual

Using WPS Function via Web-based Interface

To connect to the basic wireless network via the WPS function, follow the next steps:
1. Click the ENABLE WPS button.
2. In the WPS Control section, click the ESTABLISH CONNECTION button.
3. Select the PBC method in the software of the wireless device that you want to connect to the
router's WLAN.
4. Click the relevant button in the software or press the WPS button on the cover of the
wireless device that you want to connect to the WLAN.
5. Right after that, click the CONNECT button in the web-based interface of the router.

Using WPS Function without Web-based Interface

You can use the WPS function without accessing the web-based interface of the router. To do this,
you need to configure the following router's settings:
1. Specify relevant security settings for the wireless network of the router.
2. Make sure that the Enable Wi-Fi when WPS function is activated with hardware
button switch is moved to the right on the tabs of both bands.
3. Click the ENABLE WPS button.
4. Close the web-based interface (click the Logout line of the menu).
Later you will be able to add wireless devices to the WLAN by pressing the WPS button of the
router.
1. Select the PBC method in the software of the wireless device that you want to connect to the
router's WLAN.
2. Click the relevant button in the software or press the WPS button on the cover of the
wireless device that you want to connect to the WLAN.
3. Press the WPS button of the router and release.
Page 132
Configuring via Web-based Interface