Rack-Mounting 1/2 Width Switches
Rack-Mounting 1/2 Width Switches
The following kits are available for rack mounting 1/2 width switches.
Note. Some factory-installed screws may need to be removed prior to mounting, depending on the kit
being used.
Available 1/2 Width Rack-Mounting Kits
Kit
OS6360-RM-19-L
Note. For information on rack mounting full width 24- and 48-port switches, refer to
"Mounting the Switch" on page
General Rack-Mounting Guidelines
If you will be rack-mounting your switch(es), refer to the important guidelines below before installing.
It is recommended that two people install the switch assembly on the rack—one person to hold the
•
chassis and position it on the rack, and a second person to secure the chassis to the rack using
attachment screws. (Please note that Alcatel-Lucent Enterprise does not provide rack-mount screws.
Use the screws supplied by the rack vendor.)
To prevent a rack from becoming top heavy, it is recommended that you install heavier equipment at
•
the bottom of the rack, whenever possible.
Review
page 4-1
•
If you are installing the switch on a relay rack, be sure to install and secure the rack per the rack
•
manufacturer's specifications.
page 3-28
Description
Simple L-bracket for mounting one 1/2 unit in a 19" rack. See
installation instructions.
3-21.
for recommended chassis clearances before installing.
Chassis and Power Supplies
OmniSwitch 6360 Hardware Users Guide
page 3-29
for
April 2021