Siemens SINAMICS S120 Applications Manual page 42

Commissioning
5.5 Step 3: Parameterizing the drive object
3. Set the following parameters for parameterizing the Motor Data Set [MDS] to the values of
the motor you connected to the Motor Modules Booksize connected in parallel:
4. Parameterize the encoder used by you by setting the parameter p0400 "Encoder type
selection".
The TTL and HTL encoders cited in the following table are examples.
5. Set the parameter p0230 "Drive filter type" to 1 on the motor side if you are using the optional
motor reactors for adhering to the output-side minimum inductance.
Parameter p0235 "Motor reactor in series number" displays the number of motor reactors
per Motor Module Booksize. The required value of 1 is already the factory setting.
6. Call up the expert list in the drive object of the Motor Modules Booksize connected in parallel.
40
Parameter Description
p0100 IEC/NEMA mot stds / IEC/NEMA mot stds
0: IEC motor (SI units, e.g. kW)
1: NEMA motor (US units, e.g. hp)
p0300[0] Motor type selection
When using a Siemens motor (p0300 ≥ 100)
p0301[0] Motor code number selection
When using a third-party motor (p0300 < 100)
p0304[0] Rated motor voltage [MDS]
p0305[0] Rated motor current [MDS]
p0307[0] Rated motor output [MDS]
p0308[0] Rated motor power factor [MDS]
(Only for p0100=0)
p0309[0] Rated motor efficiency [MDS]
(Only for p0100=1)
p0310[0] Rated motor frequency [MDS]
p0311[0] Rated motor speed [MDS]
p0335[0] Motor cooling method [MDS]
0: Natural cooling
1: Forced ventilation
2: Water cooling
3001 1024 HTL A/B R
3002 1024 TTL A/B R
3003 2048 HTL A/B R
3005 1024 HTL A/B
3006 1024 TTL A/B
3007 2048 HTL A/B
3008 2048 TTL A/B
3009 1024 HTL A/B unipolar
3011 2048 HTL A/B unipolar
3020 2048 TTL A/B R, with sense
Motor Modules Booksize parallel connection
Application Manual, 01/2020, 6SL3097-5BF00-0BP0