Honeywell Performance Series User Manual page 76

76 | Performance Series 5 MP Fisheye IP Camera User Guide
Video Motion Detection
Parameter
Enable
Working Period
Anti Dither
Area
Record
Record Delay
Send Email
Snapshot
Configuring the Working Period
Configure the arm/disarm schedule. Click Setup to open the Working Period page. See
Recording Schedule and Snapshot Schedule on page 59
You can configure up to six periods per day. Draw a circle in the table to enable the
corresponding time period.
www.honeywell.com/security
Figure 6-1 Motion Detection - Video Detection Configuration Interface
Table 6-1 Motion Detection Configurations
Function
Check to enable motion detection.
Configure the arm/disarm schedule. Click Setup to open the Working
Period page. See
information.
The system logs and records only one event during the anti-dither
period. Choose an anti-dither period from 0 to 100 seconds.
Configure the motion detection region, its sensitivity, and area. The
default settings covers the entire area. See
Detection Area on page 77
When Record is enabled, motion detection will trigger a recording.
The system can delay stopping a recording for a specified time after the
alarm has ended. Choose a delay period from 10 to 300 seconds.
When this function is enabled, the system sends an email alert to you
when an alarm occurs. The email settings must be configured for this
feature to be used (see
Check to enable the system to save motion detection snapshot files (still
images) while the motion detection event is activated. See
61 for information about configuring where snapshots are saved.
Configuring the Working Period on page 77
Configuring the Motion
for more information.
SMTP (Email) on page
for more information.
for more
53).
Path on page